Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Spring Repair for Pembroke Pines Homeowners
A broken spring usually announces itself with a loud bang from the garage, and after that the door won’t lift. If that’s where you are right now, you’re in the right place: we handle garage door spring repair in Pembroke Pines, often the same day you call. Our technicians have up to 11 years of experience, and we work on the torsion and extension springs found on nearly every door in town, from the older single-car homes near Pines Boulevard to newer two-car builds out west. Springs are the one part of a garage door system that stores enough force to hurt someone, so this isn’t a job for a general handyman. Call (855) 529-2078 and we’ll get a trained technician out to take a look.
What Our Garage Door Spring Repair Service Includes
Spring work covers more than swapping a coil of steel. Here’s what each part of the job involves and when it comes up.
Torsion Spring Replacement
A torsion spring is the horizontal coil mounted on a shaft above the door, and it does the heavy lifting by twisting as the door closes and unwinding as it opens. When it snaps, the door becomes too heavy to lift by hand safely and the opener strains or stalls. We replace torsion springs sized to your door’s weight and track, and we replace matched pairs together because a new spring paired with a tired one wears unevenly and fails early.
Extension Spring Replacement
Extension springs run along the horizontal tracks on each side of the door, stretching as the door closes. They’re common on older doors and on some lighter-weight models, and they’re the type most likely to cause injury when they break because they snap back toward the front of the garage. We replace them in pairs and check that the safety cables are intact at the same time.
Broken Spring Repair
Most spring calls are for a spring that has already broken, and the fix is a full replacement of the failed spring rather than a patch. A broken spring leaves a visible gap in the coil, and lifting the door by hand in that condition can drop it on you. We confirm the break, check the cables and drums for related damage, and get the door balanced again before we leave.
Spring Adjustment
Sometimes the spring isn’t broken but the door has gone out of balance: it drifts down on its own, slams shut, or feels unusually heavy. That usually means the tension has shifted and needs to be reset to match the door’s weight. We measure the door’s balance, adjust the winding to spec, and test the door through a full open-and-close cycle.
Safety Cable Installation
Safety cables run through the center of extension springs so that if the spring breaks, the pieces stay contained instead of flying across the garage. Older doors sometimes have springs with no cables at all, or cables that have rusted through. We install or replace them as part of any extension spring job, and we’ll flag it if yours are missing.
Spring Inspection
A spring inspection is a close look at the coils, the winding cones, the shaft, the bearings and the cables to catch wear before it turns into a failure. We check for gaps in the coil, rust pitting, and uneven tension between the two springs. It’s a quick visit, and it’s worth doing if your door is more than a few years old or you’ve noticed it getting noisier or harder to open.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Spring Repair
We work on the brand you already own. That matters with springs because the correct spring is matched to the door’s weight and the hardware it was built with, not chosen off a generic chart. On a LiftMaster-equipped door, the opener’s travel limits and force settings are set around the spring tension, so we check both after a spring replacement. Chamberlain doors and openers share much of that design, and we know where those systems tend to wear first.
Craftsman doors show up on a lot of older Pembroke Pines homes, and the spring hardware on those models often needs a closer look for corrosion and worn cones. Raynor doors use their own spring and track geometry, and getting the replacement sized correctly is the difference between a door that lasts and one that keeps drifting. Whether you have a Craftsman, Raynor, LiftMaster, Chamberlain or any other make, we can help.
Signs You Need Garage Door Spring Repair Right Now
- A loud bang from the garage. That noise is usually a torsion spring snapping, and it’s the single most common sign of a failure. The door may still be partway up or down when it happens, so don’t force it.
- The door won’t lift, or lifts only a few inches. If the opener runs but the door barely moves, the spring has lost its tension and the motor is trying to lift the full weight of the door. Running the opener in that state can burn out the motor.
- The door feels extremely heavy when you lift it by hand. A balanced door should lift with modest effort. If it feels like dead weight, stop and call; lifting a door with a failed spring can drop it on you.
- The door slams down or drifts back open. A door that won’t stay where you put it usually has uneven spring tension or a spring that’s on its way out. It’s a balancing problem that gets worse, not better.
- A visible gap in the coil or a sagging spring. Look at the spring above the door or along the tracks. A gap in the coil means it’s broken, and a visibly stretched extension spring means it’s near the end of its life.
Our Garage Door Spring Repair Process – Step by Step
- 1
We ask what happened on the phone. The sound, the door’s position and whether the opener still runs tell us a lot before we arrive. That helps us bring the right springs and gives you a realistic idea of timing.
- 2
We inspect the whole system, not just the broken spring. We check the cables, drums, rollers, hinges and the opener’s force settings. A spring failure often stresses the cables, and we want to catch that before it becomes a second repair.
- 3
We quote before any work starts. You’ll get a written estimate covering the spring or springs, any related parts, and the labor. If we find something else during the inspection, we explain it and get your approval before touching it.
- 4
We replace the spring safely with the door secured. Torsion work involves winding a spring under high tension, and it takes proper winding bars and a controlled procedure. We secure the door, install the new spring or pair, and set the tension to the door’s weight.
- 5
We test the balance and the opener before we leave. The door should open and close smoothly and stay put halfway up. We cycle it several times, check the safety reverse, and walk you through what we did.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Spring Repair Cost in Pembroke Pines?
Garage door spring repair in Pembroke Pines typically runs $180 – $340 for one spring, and that’s the range most homeowners land in. Since springs are usually replaced as a matched pair, a pair runs about twice that. A typical torsion spring replacement falls in the $180 – $340 range per spring, and extension spring replacement sits in the same range. If a snapped spring took a cable with it, cable repair runs $130 – $250 on top, and if the opener was strained by lifting a heavy door, opener repair runs $120 – $320.
| Service | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Spring repair (matched pair) | About twice the single-spring range |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
What moves the number: the type and size of spring, whether it’s one or a pair, door height and weight, and whether related parts like cables or rollers need attention. The way to avoid overpaying is simple: get a written estimate before work starts, ask whether the price covers one spring or a pair, and ask what happens if something else turns up. Our free estimate includes the inspection, the quote and a clear explanation of what’s needed. The written estimate sets the final price, so there are no surprises when the job is done.
Garage Door Spring Repair Near Pembroke Pines – Our Service Area
We cover Pembroke Pines and the surrounding communities, including Miramar, Cooper City, Southwest Ranches, Davie, Weston, Plantation, Country Club, Palm Springs North, Miami Lakes, Miami Gardens and Hialeah Gardens. Most spring calls in Pembroke Pines get same-day attention, and nearby cities usually fit into the same schedule. If you’re in Miramar or Southwest Ranches and need garage door spring repair, we can often get to you the same day. For the full range of what we handle, see our Pembroke Pines Garage Door Repair Co page.
Serving Pembroke Pines, FL – Our Local Coverage Area
We serve Pembroke Pines and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Spring Repair in Pembroke Pines
Garage door spring repair is the replacement or adjustment of the torsion or extension springs that counterbalance the weight of your door. The springs store energy so the opener only has to lift a fraction of the door’s actual weight, and when they fail, the door becomes dangerously heavy. The repair involves installing a correctly sized spring, setting the tension, and testing the balance. Call (855) 529-2078 for an exact quote; estimates are free.
Most spring repairs take about an hour to an hour and a half once the technician is on site. A single torsion spring is quicker than a matched pair, and related work like cable replacement or opener adjustment adds time. Because we carry common spring sizes, many Pembroke Pines jobs finish in one visit. Call (855) 529-2078 to check availability.
Spring repair in Pembroke Pines typically runs $180 – $340 for one spring, and a matched pair runs about twice that. The final number depends on the spring type, door size, and whether cables or other parts need replacing. The written estimate you get before work starts sets the price. Call (855) 529-2078 for an exact quote; estimates are free.
Yes. We service Craftsman, Raynor, LiftMaster and Chamberlain equipment, plus the other major makes, and we match the replacement spring to the door’s actual weight and hardware. Brand-specific knowledge means we set the opener’s force and travel limits correctly after a spring change. If you’re not sure what you have, we can identify it during the inspection. Call (855) 529-2078 to get on the schedule.
Yes, we offer emergency garage door service for time-sensitive spring failures, and spring calls in Pembroke Pines often get same-day attention. A broken spring can leave your car trapped or your garage open, and we treat those as priority calls. We’ll give you a realistic window when you call rather than a promise we can’t keep. Call (855) 529-2078 to book an emergency visit.
Our spring work carries a warranty on the parts and the labor, and we’ll explain the terms in writing with your estimate. The coverage depends on the spring type and the specific repair, so ask when you get your quote. We stand behind the work and will come back if something isn’t right. Call (855) 529-2078 for details on your repair.
Clear the floor in front of and under the garage door, and keep vehicles and people away from the door until the technician finishes. Don’t try to lift or cycle the door yourself once you suspect a spring has failed. If you can, note what you heard and whether the opener still runs when you call, since it helps us bring the right parts. Call (855) 529-2078 to schedule, and we’ll walk you through the rest.
For more on the full range of spring work, including garage door spring repair in Southwest Ranches and nearby, we can point you the right direction. We also handle garage door repair, opener repair, installation and emergency service. And remember that springs are under extreme tension: never attempt to wind, cut or remove one yourself. That’s a job for a trained technician, and getting it wrong can cause serious injury.
Schedule Your Garage Door Spring Repair Service in Pembroke Pines Today
A broken spring leaves your garage door stuck, and it can leave your car trapped or your garage open. We handle spring repair in Pembroke Pines with same-day availability, a written estimate before any work starts, and a satisfaction guarantee. Call (855) 529-2078 for a free, no-obligation estimate.
Written by the team at Pembroke Pines Garage Door Repair Co.